All of our products meet ASTM-1292 standards. For information on the testing that we have done with our products, please feel free to browse the Adobe Acrobat (.pdf) documents found below.
Fall Height & Thickness:
| Poured in Place | Bonded | ||
| Up to 4' | 1.5" | Up to 4' | 1.5" |
| Up to 5' | 2" | Up to 5' | 2" |
| Up to 6'6" | 2.5" | Up to 6' | 2.5" |
| Up to 7' | 3" | Up to 7' | 3" |
| Up to 8' | 3" | Up to 8' | 3.5" |
| Up to 9" | 4.5" | Up to 9' | 4" |
| Up to 12' | 5" | ||
Fall Height Testing
| Poured in Place | Bonded |
| 1 inch | 1.5 inches |
| 1.5 inches | 2 inches |
| 2 inches | 2.5 inches |
| 2.5 inches | 3 inches |
| 3 inches | 3.5 inches |
| 4 inches | |
| 4.5 inches | |
| 5 inches |
TESTING RESULTS
Flammability Testing
This test method is intended to measure the response of finished textile floor covering materials when exposed to an ignition source under controlled laboratory conditions. It is applicable to all types of textile floor coverings whether constructed from natural or man-made materials.
Static Coefficient Testing
This test determines the static coefficient of friction of tile or other surfaces using a neolite heel assembly. A neolite heel assembly with a 50 pound load is pulled horizontally with a dynamometer to measure the force required to cause the assembly to slip. After the sample is tested, measurements are calculated and reported as the static coefficient of friction.
Breaking Load
Graves Tear Strength Testing
This test method is designed to measure the tearing strength measured in the force required to continue or propagate a tear started previously in the specimen. The five highest peaks during the test are averaged for each of the three test specimens. The results of each specimen are averaged to obtain the resultant average tearing strength.